Lone Star Tire Coating XL Tire Coating Kit – Lone Star Coating

• (1) One 8 oz. bottle of (Matte Finish) Lone Star Tire Coating
• (1) 32 oz. bottle of Lone Star tire cleaner/degreaser 
• (1) pair of gloves
• (1) tire brush
• (1) applicator pads

Everything you need for a DIY tire coating job 

Lone Star Tire Coating is the best on the market, most affordable, and easiest and quickest application.  We only recommend using our degreaser in conjunction with our tire coating so make sure to purchase it as well,  either separate or in a kit   We offer the shortest prep time.

We have designed a super powerfully designed Cleaner/degreaser to go with the Tire Coating to ensure best performance. This cleaner/degreaser will allow you to be able to clean each tire a minimum of 3-5 times depending on how dirty the tire is, before applying the coating. No other coating offers this.

• We have the longest lasting shine
• Last months, not days
• Easy application
• Zero sling
• 100% washable
• Dries completely with no oily mess

Check out my demos and follow us on Facebook @Lone Star Coating Technology.

Follow us on Instagram @ lone_star_coating_technology

Lonestar Tire Coating Application Instructions.

SHAKE WELL!!!

If a coating has been previously applied to the tire you will need to completely strip it using lacquer thinner and clean the tire according to instructions below before applying Lone Star Tire Coating.

Step 1: Wear protective gloves. Spray entire tire (WHILE ITS DRY) with Lonestar SPC cleaner/degreaser. Use tire cleaning brush to scrub tire thoroughly. Get in between cracks and crevices. Rinse before solution dries, preferably right after scrub. Repeat a MINIMUM of 3 times on all tires. If solution still turns brown, repeat until it is white when rinsed.  Closely inspect every tire to make sure there is no browning or discoloring left on the tire. The cleaner the tire, the better The tire coating will adhere and perform. (You don’t have to wait for tire to dry between each cleaning)

Step 2: Let tire dry completely before applying Tire coating. A blower can be used to speed up the process.  Once tire is completely dry, SHAKE tire coating well, squeeze a moderate amount of tire coating on a foam applicator pad of your choice and apply a thin layer over the entire tire working into any cracks or crevices until purple milky haze turns clear. VERY IMPORTANT! Make sure to apply a THIN layer. Wipe away any excess or puddling before it dries. The hotter it is the faster it dries. Have a damp rag available to wipe any product that contacts anything other than the tire. Do not apply in direct sunlight.

Apply multiple coats for higher gloss. I don’t recommend more than three thin coats on initial application. Let product dry fully in between each coat added.

Step 3: Let dry and WATCH IT SHINE

DO NOT APPLY temps below 55 degrees!!!

Touch ups:

Clean the tire well with Lonestar SPC cleaner/degreaser. Agitate if needed to remove more dirt. Repeat till suds from cleaner stay white. Usually just needs one rinse for touch ups. Let tire dry completely then Reapply Tire coating. (One thin coat recommended)

Remember not to apply in direct sunlight.

Removal of coating

Use lacquer thinner to remove. Soak a towel and scrub tire well till coating is gone.

WARNING:

Do not use SPC cleaner on coated wheels. Test a small portion on any area before using. DO NOT get Tire coating on any other surfaces.