Bit Stabilizer With Ball Bearings for Dremel Flex Shaft Eliminate

By A Mystery Man Writer

Last updated 01 Jun 2024

Bit Stabilizer With Ball Bearings for Dremel Flex Shaft Eliminate

This Shaping & Modeling item by adesignuniquetools has 107 favorites from shoppers. Ships from Olyphant, PA. Listed on Nov 19, 2023
This new product was developed to drastically reduce or eliminate play at the cutter end of the Dremel Flex-Shaft Model 225 handpiece. The Cutter Bearing Cap is a fully machined metal housing and incorporates a high speed ball bearing to guide and support the cutter close to the workpiece. The elimination of cutter play will allow the user to have a better feel and control. This is critical when engraving detail, especially on glass. For 1/8" diameter shank cutters having cutting surfaces equal to or less than 1/8" diameter, simply remove the plastic nose cap on the cutter end of the handpiece, insert cutter into collet, tighten and thread the Cutter Bearing Cap on to the male 1/2-20 thread to finger tight. View the picture with the blue background: If a larger than 1/8" diameter cutting surface is used, with a 1/8" shank, that wont fit through the bearing, partially thread (half way) the Cutter Bearing Cap on to the 1/2-20 thread, insert your cutter shank end through the bearing end of the Bearing Cap and into collet. Align the flats on the collet nut with the flats on the Bearing Cap. Use a 3/8" open end wrench or small adjustable wrench to turn both at same time. The collet nut will tighten, securing the cutter, before the Bearing Cap bottoms out because of the partially threaded Bearing Cap. After bit is tightened, finish threading and tightening Bearing Cap to finger tight.

Get flex shaft at a bigger saving. Easily locks onto flexible shaft for fine grinding and replacement. Find products of Shafts with high quality at