Autofiber Saver Applicator Thin Red and Gray

The main complaint about microfiber applicators is the that they absorb too much product. Over the past few years, as expensive coatings have taken over the industry, the complaint has only grown. Microfiber applicators make coating product application easier, quicker and more efficient, but coatings typically have a lower viscosity (not as thick - flow easier) so they soak through the microfiber to the sponge, wasting valuable product. Our solution to this problem is the [Saver Applicator].

Autofiber Thin [Saver Applicator Terry] Ceramic Coating Applicator Sponge, 12 Pack

The main complaint about microfiber applicators is the that they absorb too much product. Over the past few years, as expensive coatings have taken over the industry, the complaint has only grown. Microfiber applicators make coating product application easier, quicker and more efficient, but coatings typically have a lower viscosity (not as thick - flow easier) so they soak through the microfiber to the sponge, wasting valuable product. Our solution to this problem is the [Saver Applicator].

Autofiber Saver Applicator Mini Red and Gray

Savers Cleaning Products: Applicators and Mitts

Precision Tire Dressing Applicator – Status Detail

Reducing waste and cost. Designed for use with ceramic coatings. Make your products go further and apply more evenly. Use up to 50% less product! The double sided microfiber Saver Sheet wraps around the dual density foam applicator and easily attaches to the sides of the block with velcro.

Autofiber [Saver Block & Refill] Coating Applicator Foam Block with Side Velcro and Refill Saver Sheets with Barrier Layer (3.5 in. x 2 in. x 1 in.)

The hydrophobic layer, between the outer microfiber and inner mitt layers, prevents the product from soaking through to the other side. More product is applied to the surface. Two-tone design to keep track of each side that has been used. Great for wheel coatings and getting into tight spaces.

Autofiber Saver Applicator Mitt Green and Gray

Autofiber Saver Applicator Thin 12 pack

The main complaint about microfiber applicators is the that they absorb too much product. Over the past few years, as expensive coatings have taken over the industry, the complaint has only grown. Microfiber applicators make coating product application easier, quicker and more efficient, but coatings typically have a lower viscosity (not as thick - flow easier) so they soak through the microfiber to the sponge, wasting valuable product. Our solution to this problem is the [Saver Applicator].

Autofiber Saver Applicator Mini Gold and Gray

Applicators - Detailed Image