Dremel 105 Engraving Cutter – vertexpowertools

By A Mystery Man Writer

Last updated 20 May 2024

Dremel 105 Engraving Cutter – vertexpowertools

1/8-inch shank Ideal for fine detailed work Engraving bits can also be used for carving and routing Ideal engraving, carving and routing Use on wood, fiberglass, ceramics, plastic, jewelry and soft metals Recommended for detail work 1/8 In. shank User Tips Secure objects to a stable surface while working. For best re
1/8-inch shank Ideal for fine detailed work Engraving bits can also be used for carving and routing Ideal engraving, carving and routing Use on wood, fiberglass, ceramics, plastic, jewelry and soft metals Recommended for detail work 1/8 In. shank User Tips Secure objects to a stable surface while working. For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit. Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure. Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact). If chattering occurs, increase speed.